Used Wepackit Tray Former Glue

The 300TF Mechanical Tray Former is a heavy duty tray former designed for sustained 3 shifts per day production. The 300TF is fully automatic, operating either on-demand or as integrated to a fully automatic loading system. Smooth and consistent tray formation is achieved as tray vertical formation processes are supported by linear bearing bushings on dual 1-1/4” harden ground shafts. 

• Output: up to 35 trays per minute depending on application
• Tray blank dimensions:
  • Length: 8-20 inches
  • Width: 8-20 inches
• Nordson hot melt system
• Mechanical operation
• Electrical:
  • Volts: 220
  • Frequency: 60 Hz
  • Phase 3
• Air requirements: 80 psi
• Sequence Of Operation
  • A single flat blank is picked from the magazine and placed into the transfer position
  • A flighted chain transfers the blank to the forming section, along the way a hot melt applicator applies adhesive to the inner minor tray corner tabs
  • Once the blank is stopped above the forming section, it is gently driven through the forming section
  • The cycle is completed when the next tray pushes it out onto the discharge conveyor, giving the hot melt sufficient time to dry
• Steel frame mounted on casters