Rental Equipment: Glue Bottom Seal Case Erector
3 Rental Items
Page 1 of 1
Glue case erectors fold the two bottom minor flaps of an case blank, then apply glue to both of the minor flaps and fold over the major flaps. The formed case is then held for a short time to ensure that the glue dries and hardens, providing a strong seal. Glue sealing of cases can also mean less change outs when compared to tape, saving time during production runs. A glue bottom seal case erector can use either cold or hot melt glue.
Wexxar WFH Automatic Glue Bottom Seal Case Erector
Used Wexxar WFH Glue Bottom Seal Case Erector with: Powered blank case magazine with pin and dome case forming plates Production output rate: Up to 20 cases per minute, depending on application...
Combi 2EZ-XXL Case Erector Bottom Glue Sealer
Used Combi 2EZ-XXL Case Erector Bottom Sealer with: Dual belt driven case erector Production output rate: 8 cases per minute Minimum case size: 21...
Combi 2EZ Hot Melt Fold Over Case Erector w Gluer
Used Combi 2EZ Case Erector with: Case size range: Minimum: 6 inches long x 4.5 inches wide x 4.5 inches tall Maximum: 18 inches long x 9 inches wide x 16 inches tall Manual push button controls...
Showing 1-3 of 3 Items